1 1 5 6 7 12 13 14 15 8 10 11 9 2 3 4 4 3 Assembly Instructions Mountain fold(dotted line) Make a mountain fold. Valley fold(dashed and dotted line) M...
9 downloads
21 Views
321KB Size
Moai statues, Chile: Assembly Instructions
Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe
Before starting assembly:Writing the number of each section on its back side before cutting out the sections is highly recommended. (* This way, you can be sure which section is which even after cutting out the sections.)
http://www.canon.com/c-park/en/
Indicates where sections should be glued together.
Parts 1 - 11 4
4
3
3 2 The surface of part 4 with the triangle is the front side. The surface of part 3 with the red triangle on the glue tabs is the front side.Keep these points in mind when gluing the parts together.
View of completed model *This model was designed for Papercraft and may differ from the original in some respects.
Assembly Instructions:Two A4 sheets(No.1 to No.2)
Glue parts 1 - 4 after first gluing parts 5 and 6. 1
*Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.
5
Glue the dark-colored glue tabs to part 10.
*Hint: Trace along the folds with a ruler and an exhausted pen (no ink) to get a sharper, easier fold.
12
Parts 1 - 8
6 7
Assembly Instructions Mountain fold(dotted line)
Make a mountain fold. Valley fold(dashed and dotted line)
Make a valley fold. Scissors line(solid line)
Cut along the line. Cut in line(solid line)
Cut along the line.
Tools and materials Assembly tip Caution
Glue The glue spot(colored dot) shows where to apply the glue.
8
Glue spot(Red dot)
Glue parts with the same number together.
9
13
Glue spot(Green dot)
Glue within the same part. Glue spot(Blue dot)
10
Glue to the rear of the other part.
14
Scissors, set square, glue(We recommend stick glue), pencil, used ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
11
Before gluing, crease the paper along mountain fold and valley fold lines and make sure rounded sections are nice and stiff.
15 Glue so that the seams on the rear surface match.
Glue, scissors and other tools may be dangerous to young children so be sure to keep them out of the reach of young children.
1
Moai statues, Chile: Assembly Instructions
Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe
* Build the two statues in the same way.
37
The surface of part 16 with the triangle is the rear side. Glue part 17 so that its seams align with the triangle on part 16.
38
36
Parts16 - 24
35
16
32
First glue parts 18 and 19 together, then glue to part 17. 17 17 18 34
33 19
20 29
21
25
Glue the dark-colored glue tabs to part 23. 30
Parts 16 - 21 29 31 26
30 31
22 27
23 28
24 Glue so that the seams on the rear surface match.
Finished!
2