Command and Conquer Papercrafts www.candcpapercraft.blogspot.com The Mammoth Mark III From: C&C 3: Tiberium Wars Command and Conquer and associated ar...
14 downloads
20 Views
3MB Size
Command and Conquer Papercrafts www.candcpapercraft.blogspot.com
The
Mammoth Mark III From: C&C 3: Tiberium Wars Command and Conquer and associated artworks and models are copyright of Electronic Arts. All models here are for non-commercial use and are meant to be shared openly.
Instructions Before assembling part A1, cut the circle out of the middle of part A1, cut out parts A5 and A6 and assemble as shown in the diagram.
Assemble the body as shown.
As per the body, before assembling part B1, cut the circle in the middle, cut out parts B4 and B5, and assemble as shown in the diagram.
Assemble the Top as shown in the diagram below.
Assemble the Front treads as shown in the diagram. The diagram shows the front left tread. The numbers in the brackets is the corresponding front right tread parts to be assembled accordingly.
Assemble the back treads as shown in the diagram. The diagram shows the back left tread. The numbers in the brackets is the corresponding back right tread part to be assembled accordingly.
Assemble all the parts together as shown below. Make sure the AB parts fit into the groves in the body and the top before gluing them together, to allow for a rotating turret.
A1
A3
A2
A5
A4
A6
1/9 (row1 col1)
Body
B1
B2
B7
B11
B4
B5
2/9 (row1 col2)
Top
B82 AB2
AB3 B81
B8
AB1
B91
B92
B9
B10 B3 B121
B122
B12
B131 B6
B132 B13
Top 3/9 (row1 col3)
C6
C1
C4
C5
C2
C3
Front left treads 4/9 (row1 col4)
D6
D1
D4
D5
D2 D3
Front right treads 5/9 (row1 col5)
E1
E2
Back left tread 6/9 (row2 col1)
E3
E6
S3
S1
E4
E5
Back left tread and support 7/9 (row2 col2)
F1
F2
Back right tread 8/9 (row2 col3)
F3
F6
S4
S2
F4
F5
Back right tread and support 9/9 (row2 col4)